Rode Wireless Go Magnetic Holder

The Holder is made out of 2 seperate pieces, one to clip the Rode Wireless Go onto and the other one as magnetic back piece.

The holder allows you to easily clip your Rode Wireless onto your shirt without having to crumble it.

Since the weight is distributed across a bigger space, it also holds on better than with the clip on the Mic.

It it compatible for both the Wireless Go and Wireless Go 2.

Works great on thinner clothes (tested on t-shirts), but not very good on hoodies and thicker clothes.

One pair requires 12 Magnets (Diameter: 6mm, Height: 2mm) in total (6 on each piece).

To insert the magnets, add a pause before printing the last 2 layers.
Front piece: before layer 22 (4.40mm)
Back piece: before layer 14 (2.80mm)

Make sure your magnets are inserted corretly.

I recommend turning the magnets in the middles of the pieces the other direction (so S-N-S on each side) so it's only able to clip together at that position and thus forces the inner piece to move the same as the outer piece when moving it on the shirt.

The thinner side on the back piece and the full (bigger) side of the front piece have to be facing the bottom to print.

Inspired by https://www.printables.com/model/483309-rode-wireless-go-magnetic-mount