Joycon VR Full Body Tracking Holder

Hi! :3

If you're like me - that is, too broke for proper FBT but still wanna hang out with your favourite furries and anime girls on VRC and also like to use your legs - I have good news for you!

The joycon tracking method isn't new, however I can't find any good solutions on how to mount the controllers to your body. Well, NOW you can actually do that very easily! You just take something like a belt, put it through the loop, slide your controller into the rail et voilà! I would recommend putting some clear / electrical tape over the top to make sure your controller doesn't slide out by itself.

Print as many of these as you require. Keep in mind, you might want to mirror the object depending on the side of your body.

Print should fit perfectly at a 0,24mm layer height and 0,44mm extrusion width. At least it does for me (E3S1Pro)

PLEASE PLEASE PLEASE don't be stupid and cut off your circulation with those belts, okay? 

I AM NOT RESPONSIBLE FOR ANY BODILY HARM, MECHANICAL FAILURES OR ANY CONSEQUENCE THAT MIGHT ARISE FROM USING THIS. USE ONLY AT YOUR OWN DISCRETION!