Rovyvon E8 Tail clip magnet attachment

Tail clip for the Rovyvon E8 Angel Eyes to hold a magnet. I used an "11.4mm x 11,4mm x 4.7mm" magnet in this project.

The measurements were made really tight for a better hold, so you will have to push the magnet in the model while still hot. If you want to use a smaller magnet, use hot glue or design an adapter part.

The tail clip will fit just right in the flashlight. There is a pass-through hole in the widest part for you to put a pin to hold in place. The pin can be made of a cotton swab or you can print it yourself.

Print Settings

Printer Brand:

ELEGOO

Printer:

Rafts:

No

Supports:

Resolution:

0.2mm

Infill: