PELA U2022 wheel brim protection

I highly recommend printing this as the model is oriented, on it’s side, for maximal strength. Use a brim if you’re having problems with adhesion.

-If you print it with PETG and with the largest area flat to the bed you will get a significantly weaker print in the vertical part of the model (where the holes are)!!!

I printed mine in PETG but maybe TPU is better, I also considered Nylon (PA), time will tell..

Please let me and others know what you used and your experience!!

You can use M4x8 screws, they will thread themselves, or just use a zip-tie through both holes in a single loop or at the bottom around the claw.