Ender 3 Cable Chain Extruder Mount

Optimal for direct-drive setups! Unlike other extruder chain mounts, this one does not use chains from the old Bowden extruder location to the printing head. If that was the case, at max Z height, the chain's will crash into the top extrusion. This will break the chains and may even cause issues with very tall prints.

— — — — — — — — — — — — — — — — — — — — — — — — — —

You will need a minimum of 2 M3 x 6mm screws and nuts!

If you don't have those screws on-hand, check out DeadGlider's Remix!

Cable Chain

Ender 3 Cable Chain by Jwhiskey3D