Shelly 1 / 1PM DIN Rail mount for Wago 221

I reremixed the version of boinappi which is a remix of the magnificent design from Marc Neuhaus to fit a Shelly 1PM.

Heat inserts are very nice but unfortunately i don't have some ;-) 

Will fit for Shelly 1 and 1PM, please be aware they switched the position of SW and I/L1

You will need: 

• 1x Shelly1 / 1PM
• 4x Wago 221, 3 cable version
• 2x M4x10 cap or other head screws (select respective Din Mount version)
• 4x wire terminator, isolated (please use them)
• 30cm flexible wire

Shelly will not be flush with the holder and poke out 2mm or so. There is also no sufficient protection against touch.

Printed in PLA, 15% infill, 0.16mm, 0.4 nozzle

Changes:

Housing:

• M4 threads printed in place instead of heat inserts 
• Labels are mirrored to avoid crossing cables inside
• Labels changed from negativ to positv (0.2 mm)
• Added a cutting at the bottom for easier installation
• Shelly logo added on the top 

DIN mount version 1:

• Countersink holes added (5mm) for the M4 countersink screws

DIN mount version 2:

• Normal holes added (4.5mm) for cap or any other head M4 screws

Housing:

• M4 threads printed in place instead of heat inserts 
• Labels are mirrored to avoid crossing cables inside
• Labels changed from negativ to positv (0.2 mm)
• Added a cutting at the bottom for easier installation
• Shelly log added on the top 

DIN mount version 1:

• Countersink holes added (5mm) for the M4 countersink screws

DIN mount version 2:

• Normal holes added (4.5mm) for cap or any other head M4 screws