Vitamin effervescent tablet modular holder/stand. Very small print. Fits most brands.

My effervescent tablet tubes kept falling over on the shelf, so I just needed something simple to keep them standing up.  I remixed an egg holder to fit the purpose, allowing me to add as many holders as I need in various configurations.

I used the following settings:

Height: 0.20mm speed
Filament: PLA
Supports: none
Infill: none

The print time for each holder was around 21 minutes and uses less than 4g filament.

Changed the size so that the hole will be a good fit for the vitamin effervescent tablet tubes.