Gamers Outreach Cart Xbox Series X Sync Button Pusher

This is a add on for Gamers Outreach (GO) Carts that allows you to hit the sync button without unlocking the case. it consists of a flexible button plate that pushes a captive rod into the button. i used a bamboo chop stick as the push rod but anything 4-6mm in diameter. 

the button plate needs to be printed on a multicolor printer like the bambu labs carbon x1. it includes a technically optional clear first layer that guarantees good adhesion for the detailed letters and assures a smooth, wipeable outer surface

1. mount console where it will be
2. line up and hot glue the guide in front of the sync button
3. line up and glue the button into the front slot so that the hole lines up with the guide
4. fit and cut the rod to fit. i normally start a little long from measurement and trim down slowly for a good fit. you may also need to taper the button-end so it loose fits in the hole
5. place the rod and the clips. optionally glue the clips but make sure the rod doesn't get glued