Piggy bank with two coin slides for commercial use!

Piggy bank with two coin slides for commercial use!
This is a licensed model that will allow you to sell 3D prints!

You can find the model licensed for private use only here:
https://www.printables.com/pl/model/705509-piggy-bank-with-two-coin-slides-piggy-castle-bank 

==========
>> This is an update of the model with a few differences!

General information about the model:

Size: 153 x 108 x 232,5 mm (XYZ).

Maximum coin size for a larger slide: ⌀30x3,5 mm
Maximum coin size for a smaller slide: ⌀21x2,5 mm
Maximum coin size for direct insertion: ⌀30x3,4 mm

Slide time from the smaller slide: ~ 1,5s
Slide time from the larger slide: ~3s

Recomended printing paremeters:

Layer height: 0.2 (or less)
Filling: 15% triangles (or other)
Perimeters: 3
Support: not required
Brim: not required
Raft: not required
Scaling: I recommend printing 1:1. You can print a smaller model, but remember that this also reduces the size of the coins that can be used! I do not recommend printing less than 80%.

Print time on Anycubic Kobra 2 Pro: 8 hours at a speed of 230 mm/s
Filament type: PLA
Filament use: ~90 m/~270 g

====

You can sell 3D prints, but sharing or redistributing the 3D file is still prohibited.