Kingroon KLP1 220mm head fan

Note : it does not work on the 230mm version. See the commentary section.

10/03/2025 : v8 raised version got an airflow improvement after beeing water tested

                        v9 same airflow for non raised model.

03/05/2024 : v7 add a raised version, 7mm, to use a triangle-lab melt extender.

05/04/2024 : v6 v4-5 were too fat, this version is the best so far that fit my printer !

04/04/2024 : v5 ugly : quick fix because v4 was too hard to fit.

03/04/2024 : v4 complete redesign of the donut part : much more airflow. May be a little hard so fit.
28/03/2024 : v2 improved design, less back pressure more aero internal :-)

I'm so sorry for this shitty design !

It's so ugly !

I just mix the original shroud with the upgrade version of the Anet A8 in tinkercad.

I'm so doomed !

Please spare me the eternal hell's flames !

Work a little better than the stock one.

https://www.printables.com/fr/model/558389-kingroon-klp1-head-model-fan-duct-for-5015-fan

https://www.thingiverse.com/thing:1620630

Category: 3D Printer Parts