The author remixed this model.
adapted quickdraw probe to the mount
https://github.com/Annex-Engineering/Quickdraw_Probe
added 3mm to the probe as my E3D chc chinese clone nozzle is too low.
will need to manually remove the probe during probe calibration.
need total 7x 3mmx6mm magnet instead of 4
2 for mount , 4 for the probe and 1 for dock
As i wanted to mount to be adjustable i have edited and made a 2 piece dock
As for the dock it will need to pause at layer 20 and insert 1 magnet
The probe will need
1x endstop switch
2x 1.4 screw will need to be magnetic so that it will not fall off the dock.
4x 3mmx6mm magnet.
As for the mount
will need hotglue the wires to the mount and press in the 3mmx6mm magnet.
i am using all N52 magnet fyi.
polarity of the magnets are important so test them before inserting them.