1 M3 16mm 1 M3 nut 1 M4 washer
The screw only serves as a support for the plastic so that it does not break so easily due to layer alignment. Cap (3) then closes the hole as a lid.
Hopefully you can see in the photos how it is intended. Cap needs a bit of force, I closed it with a small clamp.
I have printed everything in PLA.
0 mirro of 1 mirro keypart
3 is cap
4 is dual mount
5 mirro of 6 single mount
I split the bracket that has a holder on two sides in the middle and then pressed it with dowels in slicer is not ideal but it works.
Category: Replacement Parts
The author marked this model as their own original creation. Imported from Thingiverse.