As mentioned earlier, this is a functional 20mm hollowed-out air filter with a decibel reduction bar designed for SACHS mopeds. In my experience, the decibel reduction feature is somewhat effective. Depending on your setup, the filter will provide ample airflow.
1 | IMPORTANT ||||||||||
Printed on a Bambu Lab XC1
All printed in PA12 by eSun (Nylon is durabale against Fuel & Oil)
Support is sadly needed.
I take no responsibility for any damage done to your moped by my designs; use caution!
Always check the law if you're allowed to install them; also, here I take no responsibility if you get in conflict with your local law. I suggest only using it for showcasing purposes.
Thight fit, might need to push it a bit.
3x M5 screews needed
1x M3x5 screew needed
2 | PRINT SETTINGS ||||||||||
Layerheight: 0.20mm
Walls: 3
Infill: 50%
Infill Pattern: Gyroid
No Brim
Support: Tree (manual) Orientation: Flat
3 | DRAW SUPPORTS ||||||||||
If you like this Design, share some Love 🧡 & leave a Like 👍