Easter Egg (accepts LED Tea Light)

The following models are for an Easter Egg that stands approximately 4.1" (105 mm) tall that will accommodate an optional 1.4" diameter LED Tea Light.  The Egg can also be used for home decor other than during Easter.  These models print without supports. I recommend wall loops set for 3 and a line width of 0.15 or 0.16 mm.

The _Open model has a 1.5" diameter hole at the base for an LED Tea Light. This model has a relatively small area that contacts the printer's build plate. If your printer has issues with plate adhesion I recommend printing with an Inner Brim or use the _Breakaway model or if your not intending on using an LED Tea Light use the _Solid model. My P1S prints this model with no issues using the Cool Plate.

The _Breakaway model fills in most of the 1.5" diameter hole at the base with breakaway tabs. This greatly increases bed adhesion. After the print is complete, the fill disc can be easily removed to reveal the 1.5" diameter hole to accommodate an LED Tea Light. This model eliminates the need for a brim.

The _Solid model gives a solid base yielding the greatest bed adhesion. Use this model if you have no intentions of using an LED Tea Light.

Important Notice: Do Not use a flame-based candle for your Tea Light.