Anycubic Kossel lightweight Flying Extruder for Bondtech BMG and LGX and clones

For this Flying Extruder Kit implementation I didn't use the classic sandows or spring way. In this setup the extruder is lifted with rectractables strings from a set of badge/key holders.

For my setup I'm using a DDG Extruder V1 by Triangle-Lab. This is a 100% compatible clone of Bondtech's BMG Extruder. I also tested this kit with a genuine Bondtech LGX (Large Gears eXtruder) extruder and its totally compatible. You can just replace the BMG Extruder with an LGX model.

A batch of badge holders like the ones I used for my setup was about 10 € the box of 4. I decided to use 6 badges to lift my extruder because DDG Extruder + pancake Nema 17 stepper motor is pretty heavy. With a lighter extruder and motor you could probably use 3 or even just 2 badge holders.

Also note that my Flying Extruder design can work with any Kossel or Delta 3D printer. The trick with the badge holder can be used in even more setups and probably with differents types of 3D printer.

How to build it?

1. Download and print the 2 parts. The recommended material is ASA.
2. Assemble the printed parts with 2 M3 screws with washers and 2 square nuts.
3. Remove the plastic part that holds the preasure button (cut it) from the badge holders.
4. Attach each badge holder's ring to an hole in the top plate part.
5. Attach the BMG/LGX/DDG extruder and the motor to the motor bracket and secure it with the included screws.
6. Attach the badge holders to the frame of the printer. I used velcro scratch cable ties to accomplish that. You can use any cable tie you prefer.

Benefits

A Flying Extruder with short bowden tube has better extrusion / retractation and can extrude rubber like materials, ie: TPU.

This reduce the weight on the head and the results I observed are :

• There is less are none ghosting effect when using the badge holders to lift the extruder compared to the same extruder attachesd to the printers X, Y and Z carriages with sandows. 
• The head stay in place even when the stepper motors are disabled. The head will not fall down because of the extra weight of the extruder and it's motor.

Where to buy?

• M3 Hex screws, washers and square nuts, you should already have that in your stock.
• The badge holders I used for my setup can be purchased from Amazon : https://amzn.to/3uWzzE9
• Bondtech BMG or LGX extruders can be purchased from Bondtech's website.
• Triangle-Lab DDG Extruder V1 can be purchased from AliExpress.