Vase Mode eSun PLA+ spool Drawers

This is a remix of BearEssentials eSun PLA+ spool drawers which I modified so that the drawers are printable as vase mode and added a convenient finger notch to make it easy to open the drawers from the spool.

For the drawers I recommend 0.6 to 0.8mm line width, the ones pictured above are printed using 0.8mm wall thickness.

You need to print 4 hinges, I recommend gluing 2 together before use though it is not required.

You need 2 hinge clips

You need 2 left drawers, and 2 right drawers

If you wish to stack spools you will need to print a spacer for each additional spool

If you like my work and wish to support me then you can buy me a coffee!

I converted the drawers from a fixed model to a vase mode model.