Matek SAM-M8Q GPS mount
Simple mount for the Matek SAM-M8Q, for one of my own frame designs but may be useful as a basis for other's designs
0
11
0
111
updated March 10, 2024
Description
PDFThis is a basic mount for the Matek SAM-M8Q module, designed for one of my own frame designs but which might be a useful reference for other people working with the SAM-M8Q. This design uses M3 heat set inserts with a hole spacing of 29.5mm & is designed to mount flush against a 2mm thick piece of CFRP.
This mount assumes you are soldering to the pads on the underside of the board, not using the JST connector.
The hole in the base aids with removing the SAM-M8Q after fixing it into the mount with VHB tape.
Model origin
The author marked this model as their own original creation.
