Wall Mount for Eufy Pan/Tilt Camera

This is a wall mount for a Eufy indoor pan/tilt camera.

Update 4/3/2021: Extended v5

• Extended from wall another 5mm (after installing v4 and realizing it is still a little short).
• Changed arms to angle 50 degrees instead of 45 degrees in order to extend farther without making wall plate taller.
• Removed side holes on arms, now solid walls. They seemed unnecessary and looks more aesthetically pleasing without.
• Removed wire spools on top. They were too small to be useful, and unlikely to be used anyway.
• Leaving Extended v4 versions up in case anyone preferred the removed features.
• Uploaded v5 STEP file as well to allow easier modification/remix if desired.

Update 1/2/2021: Extended v4

• Added extended version with extra 10mm offset from wall. This will allow room for the original micro-USB plug without needing to turn camera base to the side or add a USB elbow.

Features:

• Extra/alternate screw holes to angle the camera base slightly to the side slightly to fit the USB power cable.
• Center screw hole to make use of standard tripod-style mounting hole on camera base
• Cuts on ~~sides and~~ back of mount to allow power cable routing from different directions
• ~~Cylinders on top to wrap / hide excess cable~~

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

Doesn't Matter

Supports:

Doesn't Matter

Resolution:

.2mm

Infill:

25%

Filament: Generic PLA / PETG