I wanted to print out filiptheking's "flower" but when I tried to slice it in Cura it would not sit flat. The first layer always showed a little area touching the build plate and the next layer being the full first layer.
I put his file into meshmixer and just used the "plane cut" feature to chop off the bottom layer to make it sit flat.
Filament is Makergeeks soulful blue: https://www.makergeeks.com/collections/maker-series-pla/products/maker-series-pla-3d-filament-285mm-soulful-blue-1kg
Printer Brand:
Wanhao
Printer:
Wanhao Duplicator i3 V2
Rafts:
No
Supports:
No
Resolution:
0.3
Infill:
10%
Category: DecorThe author marked this model as their own original creation. Imported from Thingiverse.