I wanted to print Kijai's cherry blossom but I also wanted to have a stem where I could insert it into a vase with other flowers. I didn't want to worry about any leaves breaking off so I designed this.
You still need to print the stamen from the original file to complete this great looking flower.
You will need to print this with supports.
Filament is Just PLA's lime green: https://www.justpla.com/pla175mm/green-play175-1kg?limit=100
Printer Brand:
Wanhao
Printer:
Wanhao Duplicator i3 V2
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
20%
Remove the supports, and glue to the cherry blossom.
I opened the flower itself in Mesmixer to remove the little hole in the stem. I then designed a blank stem in Fusion 360. In tinerkercad I imported the stem and the flower and used the "hole" on the flower to cut out an opening in the stem.
Category: DecorThe author marked this model as their own original creation. Imported from Thingiverse.