My wife needed some spikes for a hat that Bowser from Nintendo would wear. I designed this in Tinerkcad with some holes in the bottom, no supports needed they are small, to allow hot glue to hold better. We then used silver spray paint. The spikes are 1 inch wide by 1 inch tall.
Filament is Makergeeks white hot white:
Printer Brand:
Wanhao
Printer:
Wanhao Duplicator i3 V2
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
20%
We used hot glue to attach the spikes to a ribbon and then the ribbon to a hat.
I used Tinkercad and one of the pre-made cones. Resized it to 1 inch wide by 1 inch tall and then used tiny cones to create the holes in the bottom. This allows hot glue to hold the spikes better since I print on a glass bed.
Category: CostumeThe author marked this model as their own original creation. Imported from Thingiverse.