Vase for 3D printed flowers

I 3D printed flowers (other people's design) for my wife and wanted a vase / pot for them. I designed this in Fusion 360 to be able to hold these flowers (9 of them) and more. I have included the Fusion 360 file if anyone wants to edit this vase.

Warning, this is a long print, it took me 16 hours to print it.

The vase is 4 inches tall and 6.5 inches wide. It requires no supports to print and has a flared base to make sure it does not tip over while full. The walls of the vase are only 1.5 mm thick but being a round object they are fairly strong.

The filament is Makergeeks soulful blue: https://www.makergeeks.com/collections/maker-series-pla/products/maker-series-pla-3d-filament-285mm-soulful-blue-1kg

Here are the flowers that I printed. If you look at the remix section of each flower you will see the stems that I created for them. I did not want to use any stems that had leaves so they would not break off.

https://www.thingiverse.com/thing:84075 https://www.thingiverse.com/thing:2183529 https://www.thingiverse.com/thing:50319 https://www.thingiverse.com/thing:1864880 https://www.thingiverse.com/thing:5883 https://www.thingiverse.com/thing:1596049 https://www.thingiverse.com/thing:1429882 https://www.thingiverse.com/thing:308185 https://www.thingiverse.com/thing:2210430

Print Settings

Printer Brand:

Wanhao

Printer:

Rafts:

No

Supports:

Resolution:

0.2

Infill:

Post-Printing

After printing I bought some floral foam (the hard white stuff) to allow the flowers to stay in the vase without falling over. This allowed me to position them where I want.

How I Designed This

I used Fusion 360 to draw a profile and then the revolve command to make it a complete circle.