Raspi camara mount for the 2020 end of profile
The mount will fit on the end of the 2020 v-slot tube. The end plate is for the printing support, cut away. You might…
1
3
0
149
updated October 15, 2021
Description
PDFThe mount will fit on the end of the 2020 v-slot tube. The end plate is for the printing support, cut away. You might need also to shorten two opposite joints if there is a corner bolt through the tube.
The 4mm bolt can be used to secure the part in place but probably not needed.
These can be printer vertical with out the support
Category: 3D Printer AccessoriesTags
Model origin
The author marked this model as their own original creation. Imported from Thingiverse.
