The cover for the seacock handle with dimensions of 22.5x3.5mm. The print file's component length is 150mm. You can cut to the needed length by placing the part section below the slicer bed level. A bit of extra length makes seacock manipulation easier.
To adjust for the different handle size use x/y scaling.
Outside of engine room the PLA is fine, higher temperature material should be used in there.
Rafts:
No
Supports:
No
0.2mm
Infill:
2%
Notes:
3-4 wall lines should be used
The author marked this model as their own original creation. Imported from Thingiverse.