Desk/Wall Alto Saxophone Stand

Printing Instructions:
I printed in black and white ABS; PLA might be fine as long as the stand does not have constant exposure to sunlight and doesn't get too warm.

Flip the Wall Mount on its side to print for strongest orientation. The Mounting Rod as well as the Spacer should be printed on their flat surfaces. No supports are required.

You will need to print:
1 x Wall Mount
4 x Spacers
2 x Mounting Rods


Settings:
0.2mm Layer Height
5 Walls, Top & Bottom Layers
30% infill
Supports OFF for All Models.
Printing will use about 450g of filament with these settings. I would not recommend anything weaker. (Still much cheaper than any stand!)

Hardware:
4 x 26mm M4 Bolts
4 x 8mm M4 Threaded Inserts
2 x 6mm Wall Plugs (if you want to mount it to a wall)