QUICK-CLIP HT / Walkie Talkie Mount

A simple HT / Walkie Talkie mount using the QUICK-CLIP system.  Provided are 2 versions, a straight mount, and an angled 22.5 degree mount.  I designed the angled mount for use on backpack straps so that the radio will properly sit straight up and down without the antenna being in your face.  

If you need the angle to go in the other direction just mirror it in your slicer of choice.

Depending on how well your printer handles bridging you may or may not need supports, I have tried both with and without supports and found with supports was just a tad bit cleaner, though it worked either way.   If you do use supports I recommend tree supports from the bed.  Whatever you do print it as supplied, if you stand it up to avoid the support need it the clip will be too weak from layer line direction and most likely break in use.

For mounts please see the original designers listing. 

If you like my work and wish to support me then you can buy me a coffee!

This is an original design using the QUICK-CLIP template supplied by the designer of the QUICK-CLIP system.