Biqu H2 5015 High Flow Super lIghtweight Parts Cooling Duct

I wasn't satisfied with any designs floating around, they were either weak, delivered poor quality airflow to the wrong place, positioned badly, needed supports to print, or were just super bulky.

• This is super Lightweight - Mine is less than 10g printed in ASA
• Prints with NO SUPPORTS - Yes, there are 90s but they aren't much of an issue…
• High Airflow! - This is less restrictive and outputs A LOT of air!
• Super Clean Airflow - The Air is directed BELOW the Nozzle to only cool the part…
• Positioned for Clearance! The flat bottom is away from the part to avoid collision!
• Lower profile with the fan seated optimally.
• Horizontal Mount for a clean look! (I never use the output gear anyway)

There may be design versions later, but right now this doesn't require any modifications to the fan, it seats in very nicely, you could trim it to Improve the flow direction a little but it's not needed.

Printed using ASA you will need:

2x M3x10  

2x M3x20

1x 5015 Blower Fan. I used: https://amzn.to/3V7HJ76

I suggest printing standing up with no supports.

Message with any improvement Ideas! Keep an eye out for more projects coming soon!