Voron - DIN Mount (LRS-200, board Spider, RPi)

I looked for a different type of mounting on the DIN rail than is used in the official release of Voron parts - I was not at all satisfied with the type and design ☹

For the DIN Rail Bracket Mount you need M3x10 countersunk screws.

DIN

Adjustment of the hole for M3 Heat Inserts up to 5.0mm, so that there is not a large excess of extruded plastic.

Source holder

Adjusted the height of the part so that it can be used in the construction of the Voron 2 printer.

For the Power Supply you need M4x12 screws.