Filament Drybox [alternative mounting]

UPDATE 03.04.2024

• reuploaded a slightly improved version of “inlet_M10”

----------------------------------------------------------------------------------------------------------------UPDATE 01.04.2024

• added two new parts to fit prusament spools in one of the boxes
• https://www.amazon.de/dp/B0CBPVPDYR?psc=1&ref=ppx_yo2ov_dt_b_product_details

----------------------------------------------------------------------------------------------------------------

UPDATE 30.03.2024

• to further reduce friction, i've added new parts to shorten the PTFE tube by half the length and to minimize the need of holes into the box
• added parts: 
  • plug_thread_M6_integrated ("park position")
  • M6_plug + M6_screw if you need to close existing holes already drilled

----------------------------------------------------------------------------------------------------------------

UPDATE 11.03.2024

• Added new Filament Inlet part + washer to connect a M10 pneumatics connector due to reduce friction. Make sure the PTFE Tube is all the way in the Inlet part when assembled!
• Added new adapter part to use the spool holder with a different cereal box
• Updated description and added the purchase parts i've used so far

----------------------------------------------------------------------------------------------------------------

Description

Just another Filament Drybox with different mounting system. No specific box needed! - just a flat lid.

I've used two different cereal boxes so far. See those pros and cons for each box below in the purchase part section.

NOTE: Make sure to buy a cereal box without those “grip dents”. I bought them and thats why only spools with a maximum width of 60mm will fit.

I've added some spool adapters with various diameters for spools i own.

Just ask if you need additional diameters.

Print Settings i've used:

• printed with normal PLA
• 0.2mm layer height
• no supports needed (see slicer picture for print orientation)
• 30% infill

Purchase Parts you will need:

• any box that fits the size of the filament roll + the assembly (make also sure, that the lid is flat and does not contain any kind of angle!)

Boxes i've already tested myself:

• https://www.amazon.de/dp/B0B2HWT6PF?ref=ppx_yo2ov_dt_b_product_details&th=1
  • those contain “grip dents” but still work very nice
  • maximum spool diameter: 200mm
  • maximum spool width: 60mm
  • Prusament does NOT fit
• https://www.amazon.de/dp/B0CBPVPDYR?psc=1&ref=ppx_yo2ov_dt_b_product_details
  • still testing those boxes
  • dont have those “grip dents” but have an angle at the lid (you'll need the additional “angle_adapter_part” in order to center the filament roll in the box
  • maximum spool diameter: 200mm
  • maximum spool width so far: 65mm
  • Prusament does fit with special parts!

• 4x M3x10
• 4x M3 Nut
• 4x M3 washer
• 1x M6 Nut
• some pneumatic connectors with M6 regular thread for the air plug
  • https://www.amazon.de/dp/B07DK8FRXL?psc=1&ref=ppx_yo2ov_dt_b_product_details
• some pneumatic connectors with M10 thread for the inlet part
  • https://www.amazon.de/dp/B0C5XBDJYV?psc=1&ref=ppx_yo2ov_dt_b_product_details
• PTFE tube
  • https://www.amazon.de/dp/B07SPXY5B7?psc=1&ref=ppx_yo2ov_dt_b_product_details