Upgraded slider for Dracula's Tower Puzzle Box

This is a new slider for Dracula's Tower Puzzle Box that has the magnet insertion at the rear to provide a flat gliding surface across the base.

You can see both versions in the picture.

Printing instructions

• Print the .stl file as-oriented.
• A brim might help.

Installation instructions

• Check the magnet orientation first!
• Push the magnets in from the rear of the slide into the two openings.
• It should be a tight squeeze, but you can optionally add a drop of glue in the opening end to keep it from moving.

Other notes

• If you haven't glued the magnets in yet, you can use a small pry tool from the screw hole to push them out.

Thank you to 3D Printy for an amazing model!

The new slider inserts the magnets from the rear and keeps the bottom surface smooth for gliding across the base.