Notebook stand replacement flap (Aplic)

While the overall quality of this laptop stand is not too shabby, the flaps represented a weak point in this product. The original flaps (injection-molded ABS) both came loose after a few months of using the stand daily, and glueing them in place was only a short-term solution.

So I took an afternoon to design a stronger version of this flap, maintaining its flexibility required to install it into the stand. 

If this upload prevented you from buying a new laptop stand, or helped you in any other way, please buy me a coffee as I'm a caffeine addict :)

Notes:

• Recommended filament: PETG or PLA+
• Layer height: 0.15
• Infill: 30 - 40%
• Organic supports
• Using the UPDATED version is recommended