2006 - 2010 Honda Civic Keyless Key Fob

This is a durable, screwless, 8th Generation Honda Civic keyless key-fob. 
I've specifically came up with this design to prevent the enclosure from splitting. 
Mind you, this is a very tight, snug-fitting keyfob. 
 

DON'T FORGET TO ADD A NEW COIN BATTERY AND YOUR BUTTONS. ONCE YOU PUT IT TOGETHER, IT WILL NOT COME APART EASILY! 

In your 3D Printing Slicing Software, make sure to enable ironing on top surfaces for better precision. The knub inserts you see behind the front-plate of the enclosure might need a bit of light sanding to remove any blemishes from over-extrusion or blobbing. PLA is preferred. The front plate is a quite thick. So, you may have to dig your fingers deep to press down on the buttons. Remember to print multiple ones. There may be a scenario where the coin battery may need to be replaced in the future. The only way to take the chip out is with a thin scraping tool or flathead screwdriver. Anyways, Happy DIY-ing!