Didn't manage to take a picture of this before it was sent off with a custom 3d Printer Moon lamp....
But this is a basic base for all 3D Printed Moon lamps, and anything else. It mimics the wooden block bases you get if you buy one or buy a kit - you need to print THREE of them, and they just slot together. Use glue if you want or your printer is super dialled in and they are too loose.
I needed a quick base to give with a present of a 3D printed moon lithophane, so I quickly knocked this up as a duplicate to the wooden versions.
I'll see if I can print another one off and take a picture.
Printer:
P3Steel Toolson Ed
Rafts:
Doesn't Matter
Supports:
No
Resolution:
200
Infill:
20
Filament: any PLA
something dark
Notes:
PRINT THREE!!! Print them laying flat on the bed with the mortise and tenon pointing up - so no supports needed.
Post-Printing =============They should just slot together to make a tri-pronged base to sit the sphere on. Use some glue if you want it to be more strong or the fit is too loose.
Category: OtherThe author marked this model as their own original creation. Imported from Thingiverse.