Respirator-RJ-V2

This is improved version of my previous design. I added drains for condense water inside and hole with plug for some sponge material for holding that condensate.
I also added front cover so it will look not as suprised face :-D
This is not for profesional medical purpose, but it can be sealed and work for other uses such as dust protection etc.

It,s glasses friendly. Sharp edges under eyes should be heat-bended or cut acordingly to your face.

Filter grids was choose for tight fit and for not being loose while working.
There is no exhale valve because in my country, facemask with exhale non-filtred valve are banned for using.

If you tip me i will send some photo of my printer being fed by plastic from your tip :-D

Print Settings

Rafts:

Yes

Supports:

Yes

0.2

Infill:

20