Statue of Liberty - Breaking Bad

Print at 100% infill with a layer height of 0.2mm with a base layer of 0.32mm

Use any colors you'd like, either via AMS or by manually swapping filaments as indicated below.

Filaments Used:

PLA SPARKLE BambuLab Slate Gray Sparkle Transmission Distance: 1

PLA BambuLab Matte Marine Blue Transmission Distance: 15

PLA BambuLab Matte Lemon Yellow Transmission Distance: 15

PLA BambuLab Basic Jade White Transmission Distance: 1

Swap Instructions:

Start with Slate Gray Sparkle

At layer #5 (1.12mm) swap to Marine Blue

At layer #8 (1.72mm) swap to Lemon Yellow

At layer #14 (2.92mm) swap to Jade White for the rest.

If you want to resize the print, DO NOT change the Z axis.

Happy printing, and share your make!