Telescoping spacer

Sizes:

• Large - from 47 mm to 77 mm
• Medium - from  32 mm to 48 mm
• Sall - from 25 mm to 34 mm

Printing

First, print the 4 necessary parts. For the nut and body, I recommend using the same size to achieve the full range of motion. However, they can also be mixed and matched. After that, choose a holder that best suits your needs. Any holder can be paired with any size nut, and the pin will also be universally compatible.

Assembely:

1. Push the pin thrue the holder.

1. Push the pin thrue the nut

1. Screw the nut on to the main body

The tops are not intended to be removed. In some cases, with certain filaments, some of the clips holding the top on the nut may break. However, as long as at least one clip remains, it should be fine.

Tool

The provided tool can be used to tighten the nut if more force is needed than finger-tight.