Ergonomic Tap Wrench

Please post a make if you found this print useful. Thanks! 😀

Notes

• Works perfectly with 3d prints. Haven't tested on anything else.
• Fits taps from M3 to M8. Larger sizes will probably work, though likely not smaller ones.
• Ergonomic in your hand.
• Well balanced, with the tap at the centre of the wrench.

Bill of Materials

• M5 tap to tap the hole for the bolt (I realize this is a chicken or the egg situation, sorry)
• M5 bolt

Print Settings

• 4 walls/tops/bottoms
• 40% infill
• Print the block at 100% infill
• No supports

Sources

• Knurled thumbscrew by Elothan 🙌
• My previous tap wrench

Buy me a coffee if you like: https://ko-fi.com/bassamanator

This design is:

• more ergonomic in the hand.
• better balanced, with the tap at the centre of the wrench.