Do you have any images of printing orientation and support structure please?
RC car Tyre 30mm wide.
Dieser Reifen passt zur 30mm Felge in meinem Profil.
Update 2: diverse Verbesserungen
19
183
1
808
updated
March 8, 2024
Makes
Comments
@Gigabeast Hi,I would recommend to lay it flat on one of the two outer Sides. You only need to add Support that is touching the Printbed because the other supports are already built in. Just go with your favourite support pattern. I wouldn't recommend Tree support because it would be waste of material.
@ChrissiSchmi_1809672 That's great, thanks. Eeek it's going to take 14 hours to print each tyre on my Neptune3 Pro, hahahaha, I have to print TPU very slowly. I'll also have to tweak the size I think because my rims seem to be 57mm instead of 60, it's a very old Tamiya, I'll have to check the tyre width as well. Thanks for publishing this model though, I'm hoping it will be the right pattern when I take my old tyres off to check the rim shape :o)
