BRZ/GR86 interior trunk pull handle

I wanted a handle to grab for trunk lid closure that I could grab from any side and angle, so here's my solution.

I printed with 45% infill on FFF (on a TAZ 6) and will do a 100% infill SLA print later (Formlabs Form 3).  Weak point is the cylinder as wall thickness was limited by existing parts, and that's where the fulcrum is as you pull down.

I added to both sides (same part).  Only requires one screw removal at a time using 10mm nut driver.

EDIT:

See comments for updates.