Samsung Galaxy S23 Ultra cover PETG and TPU models

Updated model 

Edit 4.2.2025

Added PETG model That can use also camera cover thath can be seen in gallery.

I printed mine without any solid top-, bottom layer and perimereters. Just printed 3d honeycomb with 50% infill. It is very lightweight.  

Edit 30.1.2025

Updated model. Because camera modules are so thick, I decided to create separe camera covers. Case can be thinner and therefore phone wont feel so bulky.

Camera covers has a tiny pocket or sleeve witch held them in tpu case, They seem to held pretty good no glue needed. Can be printed with PLA or PETG

There is two different kind of models to choose for cameramodule.

 .3mf file  also included, where I set without top and bottom layer, but top most layer is closed.

I find that cases are much faster to print this 3d honeycomb which you can see through, but it still covers phone nicely.

Edit 20.4.2024

I wanted to print cover with two materials so. First part is TPU and then I made color change and put PETG with carbonfiber in middle. I tuned temperature after change to PETG to 245 Celsius and speed to 80%. Then last part is again TPU with original temperature 230 Celsius.

Bottom layer set to zero and infil is 3D honeycomb with 25% infill.

Buttons can be printed with pla or petg and slide in place.

Edit:5.3.2024

Updated model. Rounded outer edges a little (feeled too sharp), also aligned camera holes to sit better.

Added also model with buttons in place can be also printed like that.