Nissan Note Air Vent Phone Holder Mount, prints without support.
Provides very satisfying click as pushed into place, hole is for 3mm bolt used for the particular phone mount I bought. designed for UK RHD model but I would imagine it could be mirrored in slicing software for use in international LHD models as the contour looks the same.
Printer Brand:
Wanhao
Printer:
Wanhao Duplicator i3 Plus
No
Supports:
No
0.2mm Layer Height
Infill:
20%
Notes:
print on it's side, no support needed.
It took 5 design revisions to get the geometry of the slope correct!The author marked this model as their own original creation. Imported from Thingiverse.