Wire Management Bracket

This is a simple bracket system that I used on my Hypercube Evolution but this can be used on just bout anything. See pictures to get an idea of how I use it. There is a small bracket and a medium bracket. Apply adhesive to one side of the bracket to hold it down to a surface, in my case, plywood. Then you can easily route your wires through it to keep things tidy. You can also zip tie the wires to the bracket side to keep them in place.

Print Settings

Printer:

Hypercube Evo

Rafts:

No

No

Resolution:

.20

Doesn't matter

Filament: Any PETG Any

Notes:

I recommend PETG. Print with the channel side down on the bed.