MoldMate for Multi Shot Keycaps (artisankeycaps) by xCaps (makenmodify)

This is a tool for making multi shot artisan keycaps.
The tool helps you to keep the mold in the wanted rotation.

There are two versions and two sizes:

Stepped version:

• gives you reproducible steps
• holds mold reliably even at 90°

• locked into certain angles ### Basic version:

• gives you the most flexibility

• less steady at 90°

• angles harder to reproduce ### Sizes:

• one version for 32mm molds (plus 1mm clearance)

• one version for 41mm molds (like $ynth molds, also 1mm clearance) If you need a special size just let me know ;)

  Print instructions:

Flip the balls 180° an print it on the flat side - no support is needed as long as your printer dose reasonably well at bridging. Since the parts hold no weight you can go low on the infill.