SEGA Dreamcast Trigger - pin fix

I had the pins on the right Trigger broken off, and made a small model to fix this issue.
Was printed on a Resin printer, and glued into place. This allows the tabs themselves to still flex a little bit, so you can insert it from the top like the original (saves having to disassemble the controller even further... yes, I'm lazy okay)

My Twitter thread on the repair itself can be seen here: https://twitter.com/PointerFunction/status/1421851196248240132?s=20

It's just cutting the existing tabs flush with an exacto knife, and put this model in there.