Vented lower filler / cover for XUAV Mini Talon

This is a filler/cover for the unused cutout on the bottom of the XUAV Mini Talon, with a louvered vent added so there's more area for cooling air to exit the fuselage. It was put together using the designs from Mochanic and papo2110, so thanks to them for the hard work! lol I scaled Mochanic's filler piece down a little so it's a tighter fit on the Mini Talon's fuselage. You'll need to cut out an area of foam for air to flow, and glue this in place after.

I printed this one in PLA at 0.2mm layer height, 15% fast honeycomb infill, with 2 exterior walls. It weighs in at 29g. You'll need support under part of it, it prints good upside down with the flat surface on the bed, the way it's oriented already.

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

No

Supports:

Yes

0.2

Infill:

10-15%