AKK X2 Ultimate vTX Mount for Talon 250G and others

Prints best with standard settings for most printers, 0.2mm layer height and 0.48mm extrusion width. Best with PETG or better to withstand heat from the vTX. It's sized for a 14x14mm heat sink, which can be bought on Amazon or similar, this is the pack I used: https://www.amazon.com/dp/B08DP14GZ6?psc=1&linkCode=sl1&tag=keithluneau01-20&linkId=4daeebddb0fc9281fe79118d22e8bb15&language=en\_US&ref\_=as\_li\_ss\_tl As shown in the video here: https://www.youtube.com/watch?v=mpTKtrAMkJM

The vTX is mounted inside with a layer of foam mounting tape. Stick the tape inside the mount then trim out the hole for the hea tsink. Remove the heat shrink and label from the metal shield on the vTX, then stick it into the mount. Stick the heat sink on last.

Print Settings

Rafts:

No

Supports: