MikroTik hEX S 10 inch rack mount

This is a 10 inch rack mount for the Mikrotik hEX S router, also fits the regular hEX (thanks therealodie for testing) might fit for others as well but thats untested.

You'll need 4 M3x8 screws and 4 M3 nuts.

Print Settings

Supports:

No

Resolution: 

0.2

Infill:

15%

Filament:

PETG

Notes: 

• print two pieces of rack-plate.stl

Insert hEX S

This can be a bit tricky.

• align the holding pins on the center part to the screw holes on the bottom of the hEX S and push them in (this is why you should use PETG as it bends better)
• while pushing, slide the hEX S to the front until the rubber feets lock into the holes. This is a little difficult because of the rubber feet.

the hEX S should now be securely locked on the mount

screw together

Use 4 M3x8 screws and M3 nuts to screw the rack plates to the center piece.