Voxelab Aquila 2020 Extrusion caps

Simple end caps for the upper X gantry on my Voxelab Aquila.

After printing https://www.thingiverse.com/thing:4876137, I wanted to fill in the 2020 extrusion again, but the filament guide cuts into the available space.

Since I'm learning Tinkercad at the moment, I though I'd try my hand at replicating the stock caps, plus also design a custom one that accommodates the filament guide.

These will probably fit the Ender 3 v2 as well, but I don't have that printer to confirm.

Thought I'd post the result here in case it helps anyone else.

Edit: Added 2 new end caps, removing one of the tabs so that you can accommodate v-slot covers. I used these ones:

https://www.thingiverse.com/thing:4849882

Print Settings

Rafts: No
Supports: No
Resolution: 0.2mm
Infill: Not needed
Filament: Tinmorry PLA Orange
Notes: These are so small, they print in about 10 minutes.