Skeletal Phone Stand (PopSocket Compatible)

Sure, there are plenty of phone stands out there. But a lot of them don't work if you have a PopSocket, Loopy, or other gripping device on the back of your phone. Enter, the SPS. 

• You can use this even if the phone case has an irregular contour on the back. 
• You can charge your phone while it sits.
• You can adjust where the ledges are, to accommodate different types of chargers.
• You can adjust where the back supports are, if you REALLY need the space.
• You can set your phone either vertically or horizontally.
• Filament saving design clocks in at just 32g.

The connector is sized to work with my phones, and should work for most. Let me know if there's interest and I can make adjustable versions, or custom lengths.

Recommend you print the Combined first and test the fit - on my machine these are a snug friction fit. If the ledge and connector are too thick you can adjust and reprint just those. Optionally you can print the Fit Tester model.