Bearing Push Pull Tool Press Onewheel 55 mm x 35 mm

Onewheel bearing adaptor to push or pull the bearing out of your hub. GT bearings specs. 
Press: 55 mm outer, 35 mm inner diameter, for pressing in bearings.
Removal: 45 mm outer, 35 mm inner diameter, for pressing out bearings.

Tall model - Bearing press in
Short model - Bearing push out

PLA
2 outer layer
3 bottom and top
25 % minimal in fill
 

*If the bearing does not fit snug on the tool, you can add electric tape as a gasket to hold the bearing in place during installation of the bearing.
May required sizing of model to accomadate your printer tune.